Jul
25
2010
Our house was built in 1968 and our most recent renovation, some years ago. We retiled our shower (professional) and she had to install new valves. Since we have problems and it becomes worse. The cold tap water seems fine (hard to say because we have a water saver shower), but hot water is only turned to a hot shower. It’s almost as if you’re outside, not even look as if you were actually running, it is so small. My husband said he had the parts to repair, but he hates plumbing, fears and disassemble, it was not able to fix it and it will only get worse, or create more problems. Everyone knows what is happening could be the valves? I do not know the brand that we could not contact the manufacturer, but I hope it’s a good brand, because we were made of high quality tiles. The drips of cold water faucet when the shower, not much, but enough if you are below you! The hot water in the rest of the house is normal.
This is a preview of
We have a plumbing problem with our shower faucets- how can we fix them?
.
Read the We have a plumbing problem with our shower faucets- how can we fix them?
6 comments | tags: Cold Water Faucet, Contact, Faucets, Fears, High Quality, Hot Water, Plumbing, Plumbing Problem, Problem, Quality Tiles, Renovation, Shower, Shower Faucets, Tap Water, them, Water Saver
Jun
8
2010
The “cold tap water, it is clear that the” hot “is not it.
6 comments | tags: causes, Clear, Cold, Cold Water, Faucet, Faucet Kitchen, Hot Water, Kitchen, Kitchen Sink, murky, Sink, Tap Water, WATER, Water Faucet
Jun
8
2010
Every time you on the water, the most horrible noises coming from the tap! It does not happen with the hot water, only cold. And more importantly, because it is happening and how can I stop it?
This is a preview of
Why does my cold water faucet in the kitchen moan & groan?
.
Read the Why does my cold water faucet in the kitchen moan & groan?
5 comments | tags: Amp, Cold, Cold Water Faucet, Faucet, Faucet Kitchen, groan, Hot Water, Kitchen, moan, Tap, WATER
Jun
6
2010
I am with the right side, as indicated in the manual and it works for a few weeks then starts dribbling nuovo.Una new spring is fine with the new disc and I replaced him with another ancheNessun break the seal, only one of their hot water unoI two separate faucets fits deltaLa wheel on the seal and when I pull out the seal used above seems to chew on it, above means that the smooth side
This is a preview of
I keep having the replace the kitchen hot water faucet seal? What could I be doing wrong?
.
Read the I keep having the replace the kitchen hot water faucet seal? What could I be doing wrong?
5 comments | tags: Break The Seal, Could, doing, Faucet, Faucets, Having, Hot Water, Keep, Kitchen, Kitchen Faucet, New Spring, Replace, Seal, Smooth Side, WATER, Water Faucet, Water Seal, Wheel, wrong
Jun
4
2010
I installed new scrubbers and renovation of a building (including pipes for W / D, such as valves and drainage). We also replaced the kitchen and bathroom fittings. Both valves handle faucets. After we installed these, the water temperature drop in the building. . . Bath, shower, kitchen and W / D. I have read that on verious websites can handle mixing valves on taps to let water fall thing. The questions are: 1) How can I tap water (or know W / D) is the cause of the problem. 2) How do I know that there is something else, like / WD faulty installation 3) How the problem if I know what sia.Si Please note that the water heater a common heating system for the construction and repair 26 other condos ok so are the boiler is not a problem. Nor do we have nothing has changed in the shower and the separate hot and cold water taps, but also its temperature caduto.Grazie.
This is a preview of
Hot water not hot enough in my Condo. Recently installed new washer-dryer, new faucets.?
.
Read the Hot water not hot enough in my Condo. Recently installed new washer-dryer, new faucets.?
2 comments | tags: Bathroom Fittings, Boiler, Cold Water, Condo., Condos, Drainage, Enough, Faucets, Hot Water, installed, Mixing Valves, Pipes, recently, Renovation, Scrubbers, Tap Water, Temperature Drop, Washer Dryer, washerdryer, WATER, Water Bath, Water Drop, Water Fall, Water Heater, Water Taps, Water Temperature
Jun
3
2010
to do No other faucets in the house. Normally I turn the hot water over the sink and run away, but within 1-2 minutes, the pressure suddenly drops and begins to sink, a little shiver, “not accompanied by a low noise level. Cold water, but the pressure of cold I water in this valley observed vary widely, sometimes large, sometimes more like a heavy wire. The problem began several months ago is hot, and we owned the house for two years. It was said that all plumbing has been replaced before we bought . The sink is the hot water faucet near the stove (gas), so that is not the distance is a problem. If I turn back the heat for a few minutes and then on the pressure, but then the wire comes with the shaking. Sometimes I get a warmer period with no problem if I just turn the tap on halfway.
This is a preview of
What is causing my kitchen sink’s hot water spigot to suddenly drop pressure and make low shaking noises?
.
Read the What is causing my kitchen sink’s hot water spigot to suddenly drop pressure and make low shaking noises?
6 comments | tags: causing, Cold Water, drop, Faucets, Few Minutes, Hot Water, Kitchen, Kitchen Sink, Low Noise, Noise Level, noises, Plumbing, pressure, shaking, Shiver, Sink Faucet, Sinks, Spigot, suddenly, Tap, WATER, Water Drop, Water Faucet, Water Pressure, Water Spigot
Jun
3
2010
Yesterday, when I got home, I found that the hot water from the faucet in my kitchen is. Today, even the cold water is gone too. All other taps work well. I suspect frozen water, but it is hard to identify because my basement is finished and pipe the water to the kitchen ceiling between the ground floor and second. What can I do to thaw frozen pipes? Thank you
This is a preview of
Water pipe in my kitchen is frozen?
.
Read the Water pipe in my kitchen is frozen?
6 comments | tags: Cold Water, Faucet Kitchen, frozen, Frozen Pipes, Hot Water, Kitchen, Kitchen Ceiling, pipe, Taps, WATER, Water Faucet, Water Pipe
Jun
2
2010
I turned off the valves under the sink tight, but the hot water faucet is dripping and still not really close! I turned hot and cool under the sink and still dripping. I fully open both valves under the sink and now no hot water from the tap. . . . . but the cold still dripping! Help!
This is a preview of
I recently replaced the diverter in my Oakbrook kitchen faucet [cuz of very low pressure]now it drips [hot]?
.
Read the I recently replaced the diverter in my Oakbrook kitchen faucet [cuz of very low pressure]now it drips [hot]?
1 comment | tags: Cuz, diverter, drips, Faucet, Hot Tap, Hot Water, Kitchen, Kitchen Faucet, Oakbrook, pressurenow, recently, replaced, Sink Faucet, Tight, very, Water Faucet, Water Tap
Jun
1
2010

- Waxman
- 7617200N
- Kitchen Faucet Replacement Parts
Product DescriptionWaxman 7617200N 7617200N HandleWaxman Universal Universal Canopy Handle Features:; Fits most taps, four poster style, includes a hot water faucet handle chrome, a chrome handle and a cold water tap wrench; carded. . . More>>
This is a preview of
Waxman 7617200N Universal Canopy Handle
.
Read the Waxman 7617200N Universal Canopy Handle
no comments | tags: 7617200N, Canopy, Cold Water, Faucet Replacement, Handle, Hot Water, Kitchen Faucet, Poster Style, Replacement Parts, Tap Wrench, Universal, Water Faucet, Water Tap, Waxman